Eurotubi Pressfitting System - Technical Guide ... - Damstahl
Eurotubi Pressfitting System - Technical Guide ... - Damstahl
Eurotubi Pressfitting System - Technical Guide ... - Damstahl
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
where:<br />
ΣZ<br />
Z<br />
is the result of Z 1 + Z 2 + ... + Z n<br />
is the pressure drop of the single fitting expressed in mbar<br />
As well, the following formula is used to calculate the pressure drop of the single fitting<br />
Z = ξ • ρ • v 2 /2<br />
where:<br />
ξ is the coefficient, which depends on the fitting type<br />
ρ is the fluid density expressed in Kg/m3<br />
v is the fluid speed expressed in m/s<br />
For a practical calculation of pressure drops it is possible to refer to the following tables.<br />
13. COUPLING FITTINGS TABLE<br />
• MINIMUM DISTANCE BETWEEN TWO PRESSINGS<br />
• DOUBLE TEE<br />
• SIDE MOUNTED TEES<br />
• ELBOW 45°FF WITH ELBOW 45°MF<br />
• 2 ELBOWS 45°FF WITH PIPE<br />
• ELBOW 90°FF WITH ELBOW 90°MF<br />
• 2 ELBOWS 90°FF WITH PIPE<br />
• ELBOW 90°FF AND ELBOW WITH PLAIN ENDS 90° (long side)<br />
• ELBOW 90°FF AND ELBOW WITH PLAIN ENDS 90° (short side)<br />
• ELBOW 45°MF WITH LATERAL TEE<br />
• ELBOW 45°MF WITH LATERAL TEE AND PIPE<br />
• ELBOW 45°MF AND LATERAL ELBOW 90°FF<br />
• ELBOW 90°MF WITH LATERAL TEE<br />
• ELBOW 90°MF WITH LATERAL TEE AND PIPE<br />
• LATERAL ELBOW 90°FF AND PIPE<br />
• TEE AND REDUCTION<br />
14. CHEMICAL COMPATIBILITY OF EUROTUBI PRESSFITTING SYSTEMS<br />
Note. The compatibility values stated are generic. Liquids for food use other than water can not be included<br />
since pressfitting systems are not suitable for these elements as stagnation may form in correspondence<br />
with the joints. For more information please contact the <strong>Eurotubi</strong> <strong>Technical</strong> Department.