Setting Up and Programming the Digital Receiver - Radix
Setting Up and Programming the Digital Receiver - Radix
Setting Up and Programming the Digital Receiver - Radix
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Programming</strong> <strong>and</strong> Operating <strong>the</strong> Analog-<strong>Receiver</strong> Section<br />
6.4 Preselecting Channels from <strong>the</strong> Main Menu (Display Page 3)<br />
The settings of Display Page 3 should be altered by a trained specialist only.<br />
• Press <strong>the</strong> q key while <strong>the</strong> cursor is in <strong>the</strong> bottom display<br />
line to transit from Display Page 2 to Display Page 3:<br />
MAIN MENU<br />
> TONE BURST : A<br />
SWITCH INPUT : 1<br />
• Reset DiSEqC to A or B.<br />
• Switch <strong>the</strong> SMATV-feature ON if you want your receiver to<br />
receive DiSEqC-signals, which will only be possible if <strong>the</strong><br />
SMATV-feature has been enabled from <strong>the</strong> system menu.<br />
Version 1.0 Page 15<br />
GB