Setting Up and Programming the Digital Receiver - Radix
Setting Up and Programming the Digital Receiver - Radix
Setting Up and Programming the Digital Receiver - Radix
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Setting</strong> <strong>Up</strong> <strong>and</strong> <strong>Programming</strong> <strong>the</strong> <strong>Digital</strong> <strong>Receiver</strong><br />
7.5.2 Adjusting <strong>the</strong> DiSEqC-Controller <strong>and</strong>/or <strong>the</strong> 22-kHz Control Signal<br />
NOTE:<br />
This adjustment is used for selecting <strong>the</strong> correct segment of <strong>the</strong> frequency b<strong>and</strong>s.<br />
The DiSEqC-controller, which may be used only if <strong>the</strong> satellite system in use is<br />
equipped with a DiSEqC-switch, incorporates <strong>the</strong> correct settings for all of <strong>the</strong><br />
various parameters involved: upper/lower b<strong>and</strong>, horizontal/vertical polarization,<br />
<strong>and</strong> <strong>the</strong> type of satellite system involved.<br />
In <strong>the</strong> event that <strong>the</strong> satellite system involved is not DiSEqC-controlled, <strong>the</strong> setting<br />
for “<strong>Up</strong>per/Lower B<strong>and</strong>” will have to be manually entered by toggling <strong>the</strong> “22kHz“<br />
setting ON/OFF.<br />
Most commercially available satellite systems employ so-called “general-purpose”<br />
LNB’s where a setting of “22 kHz ON” will automatically effect a switch to <strong>the</strong> upper<br />
b<strong>and</strong>, where all digital satellite channels will be found (<strong>the</strong> factory default setting is<br />
22 kHz ON).<br />
• Use <strong>the</strong> p <strong>and</strong> q keys to highlight <strong>the</strong> “DiSEqC/22kHz“ field.<br />
• Press <strong>the</strong> MENU-key:<br />
Installation<br />
Satellite<br />
Signal Strength<br />
DiSEqC/22KHz Auto Search<br />
LNB Lokal-Freq Manual Search<br />
22KHz<br />
OFF<br />
Setup Value<br />
• Use <strong>the</strong> p <strong>and</strong> q keys to toggle <strong>the</strong> “22kHz“ setting ON/OFF<br />
or select <strong>the</strong> DiSEqC-controller required.<br />
• Press <strong>the</strong> MENU-key to confirm your choice.<br />
MENU/EXIT<br />
CAUTION:<br />
These settings should be altered by specially trained personnel only.<br />
In order to be able to receive <strong>the</strong> greatest possible number of channels, you will<br />
have to repeat <strong>the</strong> automatic-search procedures (cf. Section 7.5.5, below) for each<br />
<strong>and</strong> every available DiSEqC-setting <strong>and</strong> for both settings of <strong>the</strong> 22-kHz control<br />
signal {ON/OFF).<br />
Version 1.0 Page 21<br />
1 - 3 - 2<br />
GB