Setting Up and Programming the Digital Receiver - Radix

Setting Up and Programming the Digital Receiver
7.4 Setting Decoder Status
Selecting the TV Aspect Ratio:
Changing the DiSEqC:
• Use the p and q keys to highlight the “Decoder Status” field.
• Press the MENU-key.
• Use the p and q keys to highlight the “TV Aspect Ratio” field.
• Press the MENU-key.
Decoder Status
TV Aspect Ratio
DiSEqC Change
All Channel Clear
System Information
4 : 3 16 : 9
Setup Value
MENU/EXIT
• Use the t and u keys to select the aspect ratio, 4:3 or 16:9,
for your television set.
• Press the MENU-key to confirm your selection.
NOTE:
You will not be able to work with the Digital Satellite Equipment Control (DiSEqC)
unless your satellite system is equipped with a DiSEqC-switch.
CAUTION:
This feature is used for reconfiguring receiver setup when changes have been
made to an existing DiSEqC-distributor. These settings should thus be altered by
trained specialist personnel only.
• Use the p and q keys to highlight the “DiSEqC Change” field.
Decoder Status
TV Aspect Ratio
DiSEqC Change
All Channel Clear
System Information
OLD NEW
1 1
Setup Value
Page 18 Version 1.0
1 - 4 - 1
LNB Polar Vertical
Band Low
Sat System A
1 - 4 - 2
MENU/EXIT