Lovis 2000 M_ME - Reference Manual.pdf

6 Preparing the Instrument SECTION I : Lovis 2000 M/ME Reference6 Preparing the InstrumentThis chapter informs on how to set up the instrument after unpacking it. It doesnot give instructions how to prepare a measurement (e.g. filling a capillary). Itgives specific instructions for Lovis 2000 M/ME. If using Lovis 2000 ME inside aDMA M/DSA M, also read and follow the corresponding instruction manuals.6.1 Installation RequirementsThe setup location and surroundings should meet the requirements of a typicallaboratory.Allow the equipment to reach ambient temperature before installation. This is veryimportant if the equipment has been stored or transported at lower temperatures.Place the instrument on a stable, flat lab desk which is free of vibrations.To ensure temperature stability and trouble free measurement never locate yourinstrument:• next to a heating facility• near an air conditioning, ventilation system or an open window• in direct sunlight• on a vibrating surface or close to vibrating equipmentKeep the instrument away from magnetic fields. Those could possibly influencethe inductive sensors or electronics. Read the Safety Instructions in Chapter 2.Find all Technical Data required for installation in Appendix A.5.WARNINGUsing hazardous or flammable chemicals as samples or cleaning liquids coulddestroy the instrument and cause serious injuries when not taking specialprecautions into account.• See the section "Special precautions for flammable chemicals" inChapter 2 for information on a suitable installation place.NOTICEEnsure that the power plug and the power switch are always freely accessibleso that the instrument can easily be disconnected from the mains at any time.A strong built-in cooling fan dissipates heat through the bottom and the rear ofLovis 2000 M. Ensure that the airflow is not blocked and assure a minimumdistance of 100 mm (3.9 inches) to walls behind and besides the instrument. A second built-in cooling fan dissipates heat through the top of the Loviscapillary block. Do not cover the venting slots.34 C72IB002EN-E