Lovis 2000 M_ME - Reference Manual.pdf

7 Settings and Methods SECTION I : Lovis 2000 M/ME ReferenceTIPIf defining a TS or FAS, make sure to set the step interval so that the instrumentcan reach the end value by a whole number of steps (divide the interval betweenstart and end value by whole numbers only to find appropriate step settings). Ifyou enter a unsuitable end value, the instrument suggests a different input.Repeated Mode SettingsThese settings only apply to measurement mode "(RM) Repeated Mode".Tap "Menu > Methods > Method Settings > "Method Name" > Repeated ModeSettings".Max. Number OfDeterminationsSave Mode"Active" check box(Lovis AveragesRuntime)"Use Default "check boxMax. Repeat Value[%]The max. number of determinations which shall beperformed to get a valid repeat deviation.Defines which determinations shall be saved (all, validtwo only, or final one only).If activated, the deviation of the mean values of twoconsecutive measurements (determinations) iscalculated and compared to the "Max. Repeat Value".The measurement is valid, if this value is notexceeded. If the max. allowable deviation is exceeded,the instrument can do another determination(depending on the set max. no. of determinations).If activated, the default "Max. Repeat Value" is set.This value is the maximum allowable deviationbetween two determinations. Default: 0.50 %.7.2.4 Formula ParametersThe Formula Parameters can be used if you operate with manual input of thedensity.If you enter the density as Formula Parameters the instrument calculates thedynamic and kinematic viscosity with this/these density value(s) for this method.TIPThe instrument does no longer ask for the input of a density value when startingmeasurement.Mind to enter the correct value(s) if testing samples of different density!You can always change the value(s) in the "Quick Settings" just before startingmeasurement.To set the Lovis Formula Parameters1. Tap "Menu > Methods > Method Settings > "Method Name" > FormulaParameters".2. Enter the "Lovis Density for Start Temperature" for single temperature tests.50 C72IB002EN-E