Lovis 2000 M_ME - Reference Manual.pdf

6 Preparing the Instrument SECTION I : Lovis 2000 M/ME Reference6.3 Switching Lovis 2000 M On/OffWARNINGHigh voltage at parts of the instrument can cause serious injuries or death.• Only connect the instruments to the mains via protective earthing.• Never connect the instrument to the mains via protective separation orprotective insulation.• Make sure that the non-fused earth conductor of the power cord isconnected to earth.NOTICEBefore switching the instrument on, make sure that the correct line voltage isavailable (AC 100 to 240 V, 50 to 60 Hz). If large voltage fluctuations are to beexpected, we recommend using a constant voltage source (UPS).1. Connect the power socket of the Lovis 2000 M (see Chapter 5.1.3) to themains using the supplied power cord.2. To switch the instrument on, use the power switch on the rear.The green LED on the front side of the Lovis 2000 M indicates that the poweris on. During initialization the Lovis capillary block first moves to -90°, then to0° and stops in the home position (see Chapter 7.1.3).3. After turning on the power, the instrument waits for temperature equilibration.During this time "temp. equilibration" is displayed.4. To switch the instrument off, use the power switch.6.4 Mounting Lovis 2000 ME Module in the MasterInstrument or in the Module Housing Lovis MEIf ordering a Lovis 2000 ME module plus an Xsample module, a ModuleHousing Lovis 2000 ME and a master instrument, all items are packedseparately.In the following, Lovis 2000 M and DMA M/DSA M are indicated as "masterinstrument". Lovis 2000 ME is named "module".TIPIf combining a Lovis 2000 with an Xsample module, mount the Lovis 2000 ME inthe Module Housing and the Xsample module in the master instrument.If mounting the Lovis 2000 ME inside a DMA M/DSA M, you first need to updatethe instrument firmware of the master instrument to the version on the USB flashdrive supplied with the Lovis 2000 ME. Otherwise Error 13 will occur (seeAppendix F.2). To update, refer to the instruction manual of the DMA M/DSA M.36 C72IB002EN-E