DCP Series Maintenance Software Test Level 3 - Public Support ...

Configuring Ports
Auto Enable Ports
This option directs TL3 to automatically enable and test ports. During auto configuration,
the hardware ID of a line module is used to search a table of test chains. The appropriate
microcode for the option selected by TL3 is loaded into the line module and the PP chain
is started. The parameter line options (port, repeat count, throttle, and loopback) have
the same functions as the Enable Ports option. TL3 can not automatically enable all line
modules. A list of the line modules and their hardware IDs that can be automatically
enabled by TL3 follows in Table 2–43. Figure 2–7 illustrates the Automatic Port
Configuration menu.
Table 2–43. Line Modules and Hardware IDs
Hardware ID Line Modules
19 FEPI
40 Low Cost Async
44 Multi-Line Async (4X1)
45 Video Text 4X1
50 Low Cost Sync
54 Sync/Async RS-232 (4X1)
55 Sync/Async RS-232 (4X1) Dual Bus
60 Med SPD RS-449 (MSLLM)
61 Med SPD X.21 Dual Bus
64 DCSS 250K BPS CX
65 Twisted Pair
66 MSLLM V.35
67 Med SPD RS-232 or Dual Bus
6F Med SPD No Cable
70 High SPD Loadable RS-449
71 High SPD Loadable X.21
7D High SPD Bell 303
7E High SPD V.35
7F High SPD No Cable
A0 802.3 Ethernet LAN
A1 4X1 HS T1/E1 (ILM20-HS)
A2 Dual Bus Token Ring (ILM40-TR)
Continued
2–28 7431 8080–202