metric Oscillator - Beckman Institute Laser Resource Center

More documents

Recommendations

Info

Installing The ElectronicsControls and IndicaiorsFRONT PANEL"OPERATE": Allows wavelength to be changed or routines to be storedand recalled."SCAN": Allows changes to be made to the scan routine."MONITOR": Allows monitoring of the GCR 355nm pump energy withoutneeding any alterations in the operation of the MOPO.Figure 3-3: electronics front panel component identificationBACK PANELVoltage Selector Switch: Selects 115V or 230V ac. The switchposition must match the available line voltage.1151230VA. C. Input: power cord connection.110 switch: turns the electronics module on or off. 1 is ON, 0 is OFF.Q-Switch Sync: BNC cable which connects the GCR Q-switch syncoutput signal to the electronics module.MOPO Autotrackerm: 37 D-sub cable which connects the MOPOelectronics unit to the back side of the MOPO head.Figure 3 4 Electronics back panel component identification
Installation InstructionsSelect the appropriate line voltage range ("115" = 90 - l3OVAC range;"230" = 180 - 260VAC range.)Connect the power cord.Connect the BNC cable from the Q-switch output on the GCR laser to theQ-switch sync connection on the rear panel of the MOPO electronics.IMPORTANT NOTE REGARDING Q-SWITCH SYNC. SIGNAL: fie MOP0 710 maynot operate correctly $the Q-switch sync. cable is not connected properly andthe Q-switch signal ofthe pump laser is not being generated before the MOPOcontroller box is turned on. Ifthe "EW7 message appears when the controller isturned on, make sure the Q-switch cable is conneted and a sync. pulse is present,then turn the controller ofland back on again to ensure proper synchronization. Ifthis does not occur, although the laser may still operate, the user's experimentmay be adversely affected.Connect the 37 pin D-sub cable from the rear panel of the MOPOelectronics to the MOPO head.
Page 1: MOPO-700metric Oscillator@ Spectra-
Page 5: Table ofContentsChapter 1 : Introdu
Page 9 and 10: IntroductionThe principal of operat
Page 11 and 12: APump Signal Idlerm355 nm 400 nm 71
Page 13 and 14: Figure 1-5: Schematic diagram of th
Page 15 and 16: Dichmic Beam SepamtionThe output be
Page 17 and 18: 1. All specifications subject to ch
Page 19 and 20: Use of controls or adjustments, or
Page 21 and 22: Focussed Back Reflection SakfyLaser
Page 26 and 27: Installing The MOPO-700Conimls and
Page 28 and 29: Center the first IHS-355 on the pum
Page 30 and 31: Figure 3-8: MOPO-710 Beam Path
Page 32 and 33: Figure3-9: Location of the alignmen
Page 34 and 35: fBLOCK I NOAPERTURETURN I NQMIRRORI
Page 36 and 37: OperationOperation of the MOPO-710O
Page 38 and 39: OPERATE ModeThe operate mode allows
Page 40 and 41: Figure4-3: Backlit panel options di
Page 42 and 43: SCAN SETUP ModeThis mode of allows
Page 44 and 45: Maintenance3Preventive MaintenanceT
Page 46 and 47: Customer ServiceAt Spectra-Physics
Page 48: Service CentersAustraliaSpectra-Phy

metric Oscillator - Beckman Institute Laser Resource Center

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?