You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6<br />
6. Setup<br />
6. Setup<br />
6.1. Calibration [0] [<strong>Plant</strong>, <strong>Inverter</strong>]<br />
Configuration of individual sensors, PV arrays and environmental settings.<br />
6.1.1. Sensors [0] [<strong>Plant</strong>, <strong>Inverter</strong>]<br />
Illustration 6.1: Sensors<br />
Item Unit Description<br />
Irradiation sensor scale mV(1000 w/m2 ) The calibration value of the irradiation sensor.<br />
The value is usually written on a label at the back of the<br />
sensor.<br />
Note that this value must be entered before the inverter<br />
will recognise that there is an irradiation sensor connected.<br />
Irradiation sensor temp. coeff.<br />
% Calibration value for internal temperature correction of<br />
the irradiation measurement. Only used for irradiation<br />
sensors with integrated temperature compensation.<br />
PV temp. offset °C The temperature sensor may be calibrated using an offset<br />
ranging from −5.0 to 5.0 °C.<br />
Ambient temp. offset °C The temperature sensor may be calibrated using an offset<br />
ranging from −5.0 to 5.0 °C.<br />
S0 scale pulses/kWh In order to use an energy meter (S0 sensor), the scale<br />
of the energy meter must be entered here.<br />
For a description of which sensor to connect to the TripleLynx CN Pro, refer to the TripleLynx<br />
CN Installation Manual.<br />
6.1.2. PV Array [0] [<strong>Inverter</strong>]<br />
The PV area and the rated PV power (STC) for the installation are defined here.<br />
Note:<br />
These definitions are required to calculate PV string comparison for the plant status report.<br />
Refer to Messaging.<br />
28 L00410583-01_02
Change language