XT55 AT Command Set - Wireless Data Modules

XT55 AT Command Set7.20 AT+CLCCs3 Voice followed by data, voice mode (only in connection with single numberingscheme AT+CSNS)4 Alternating voice/data, voice mode (only in connection with single numberingscheme AT+CSNS)5 Alternating voice/fax, voice mode (only in connection with single numberingscheme AT+CSNS)6 Voice followed by data, data mode (only in connection with single numberingscheme AT+CSNS)7 Alternating voice/data, data mode (only in connection with single numberingscheme AT+CSNS)8 Alternating voice/fax, fax mode (only in connection with single numberingscheme AT+CSNS)9 Unknown (num)0 Call is not one of multiparty (conference) call parties1 Call is one of multiparty (conference) call parties (str)Phone number in format specified by (num)Type of address octect145 Dialing string includes international access code character '+'129 Otherwise (str)(+CSCS)Alphanumeric representation of corresponding to the entry found in phonebook; used character setshould be the one selected with command AT+CSCS (Select TE Character Set).The maximum displayed length of is 16 characters. If has more than 16 characters, only thefirst 15 characters are displayed. To indicate an overflow, a special character will be used as the 16th character.This is a space if the character set selected with AT+CSCS is 'GSM', or 'E400' if the character set is 'UCS2'.Due to time constraints on the necessary evaluation of the phonebook, this parameter may show a default valuein early call phases (e.g. for = ''dialing'', ''incoming'' or ''alerting''), even if a phonebook entry is presentfor the number concerned.Note• Teleservices other than voice, data, fax are not fully supported by ME. They are used only in connection withthe handling for AT+CSNS, and may therefore occur in parameter for mobile terminated calls.XT55_ATC_V03.03 Page 147 of 459 9/9/05Confidential / Released