FUJI HART EXPLORER INSTRUCTION MANUAL

FUJI HART EXPLORERProcess information panelProcess informationProcess valueAnalog valuePercent rangeUnitURVLRVDampingBurnoutTransfer functionCut PointProcess value indicated in the programmed unitAnalog output signalOutput in % - also indicated on the bar graphProgrammable unit for the softwareUpper range value (20mA)Low range value (4 mA)Damping of the output signalBurnout mode is selectable between high (over scale), hold,and low (under scale). In case on high and low burnout, theburnout values are programmable for high between 20.8 to21.6 and for low between 3.2 and 3.8 mA output signalTransfer function allows to program the output signal inlinear or square root.Cut point, (the start of the output signal in square root) forsquare root output is programmable between 0 and 20% ofoutput.14/09/2010 56/76