SERVICE MANUAL - Appliance Blog

More documents

Recommendations

Info

QUICK REFERENCE SHEETDRYER SECTIONSPECIFICATIONElectricalVolts 120/208 or 120/240Amps (circuit)Motor wattageHeat input (Watts @ 240VAC)Heat input (BTU/Hr.)Auto. Elec. IgnitionDrumSize (Cu. Ft.)FinishR.P.M.Airflow CFMDRUM TEMPERATURES (Max.opening on 1st cycle)HighMediumLowDimension (Inches)HeightWidthDepthVent CapabilityELECTRIC MODELS120/208 or 120/24030160-350 Watts3200/4500------5.7Power Paint Epoxy48 - 54180155° - 225°150° - 210°145° - 205°75 1/2”27”30 13/16”4-WayGAS MODELS12015160-350 Watts---20,000Yes5.7Power Paint Epoxy48 - 54180150° - 220°140° - 215°135° - 195°75 1/2”27”30 13/16”4-WayComponent Resistances*Electric ModelsGas ModelsDrive motor (120 volt, 60 Hz, 1/4 h.p. 1725 rpm)Motor Start WindingMotor Run WindingTimer MotorTimer Dropping Resistor (located in the harness)Heating ElementBias Heater on Thermostat4.5 Ohms3.8 Ohms2280-2300 Ohms4,400 Ohms12.8 Ohms28,000 Ohms4.5 Ohms3.8 Ohms2280-2300 Ohms7,000 OhmsBurner AssemblyIgnitorSecondary CoilBooster Coil* +/- 10% @ 77° F---------50 - 400 Ohms1200 Ohms1320 Ohms10
Connecting Drive Motor for Bench CheckOne SpeedTwo SpeedROTATION GIVEN VIEWING LEADENDROTATION SPEED L1 L2 7CCW HI 3 6,1 5CCW LO 3 2,1 5CW HI 3 6,5 1CW LO 3 2,5 111
Page 1 and 2: (/(&752/8;Ã+20(Ã352'8&76Ã1257+Ã
Page 3 and 4: SAFE SERVICING PRACTICES 2QUICK REF
Page 5 and 6: Short unrestricted vents 51Electric
Page 7 and 8: Removing the control thermostat 101
Page 9: SpecificationsLAUNDRY CENTER WASHER
Page 13 and 14: SAMPLE GAS DRYER SECTION WIRING DIA
Page 15 and 16: SAMPLE WASHER TIMER CYCLE CHARTCAM0
Page 17 and 18: The cycle signal will sound briefly
Page 19 and 20: • Prewash - When soaking is not n
Page 21: hydrogen gas. Hydrogen gas is flamm
Page 24 and 25: 5. If desired, add liquid bleach to
Page 26 and 27: • Do not combine stain removal pr
Page 28 and 29: Common Washing ProblemsMany washing
Page 31 and 32: 4. Close the dryer door and set dry
Page 33 and 34: To reduce risk of fire or serious i
Page 35 and 36: Avoid Service ChecklistBefore calli
Page 37 and 38: OCCURRENCEDRYERDryer does not start
Page 39 and 40: SECTION C INSTALLATION INSTRUCTIONS
Page 41 and 42: :$51,1* Do not allow combustible ma
Page 43 and 44: 0 IN.(0 CM )0 IN.(0 CM )1 IN.(2.54
Page 45 and 46: ELECTRICAL INSTALLATIONALL ELECTRIC
Page 47 and 48: &$87,21DO NOT CROSS THREAD OROVERTI
Page 49 and 50: SECTION D - DRYER SECTION OPERA-TIO
Page 51 and 52: ing times, hotter dryer surfaces an
Page 53 and 54: the control thermostat are cycled b
Page 55 and 56: switch, so the switch can be releas
Page 57 and 58: SECTION E - WASHER SECTION OPERA-TI
Page 59 and 60: Softener Dispenser:The softener dis
Page 61 and 62:
magnetic field pulls the armature u
Page 63 and 64:
flushing the lint out the drain. Be
Page 65 and 66:
ELECTRICAL OPERATIONIn the washer s
Page 67 and 68:
Timer Motor CircuitPower is not sup
Page 69 and 70:
Terminal M7 supplies power to the s
Page 71 and 72:
Terminal M7 supplies power to the s
Page 73 and 74:
SECTION F - TROUBLESHOOTING FLOW CH
Page 75 and 76:
Gas Dryer Completely Inoperative.No
Page 77 and 78:
Electric Dryers Timer Advances in A
Page 79 and 80:
Gas Dryers Blower Motor Runs but Dr
Page 81 and 82:
Washer SectionNOTE: Always check th
Page 83 and 84:
Washer Does Not Drain.Note: Always
Page 85 and 86:
Drive Motor Does Not Turn.Note: Alw
Page 87 and 88:
Slow Water Fill.Note: Always check
Page 89 and 90:
Washer will Not Fill in AnySetting
Page 91 and 92:
Water Temperature is too Hot or too
Page 93 and 94:
Removing the access panel:1. The ac
Page 95 and 96:
Removing the fabric selector switch
Page 97 and 98:
Removing the dryer door heat shield
Page 99 and 100:
Replacing the front duct:1. Disconn
Page 101 and 102:
Removing the control thermostat and
Page 103 and 104:
2. Disconnect the manual shut off,
Page 105 and 106:
Removing the high limit thermostat:
Page 107 and 108:
2. The blower wheel can be removed
Page 109 and 110:
3. Remove the three screw in the fr
Page 111 and 112:
2. Place a screwdriver between tran
Page 113 and 114:
Removing the water inlet nozzle:2.
Page 115 and 116:
3. Disconnect the wires from the ca
Page 117 and 118:
3. Remove the bolt from the front l
Page 119 and 120:
3. Using a 1/2” socket remove the
Page 121 and 122:
Removing the washer cabinet:1. Disc
Page 123 and 124:
NOTES123
show all

SERVICE MANUAL - Appliance Blog

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?