SERVICE MANUAL - Appliance Blog
SERVICE MANUAL - Appliance Blog
SERVICE MANUAL - Appliance Blog
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ROUGH-IN DIMENSIONS25 ¼ IN.(64.13 CM )2 ½ IN.(6.35 CM )16 ¼ IN.(41.27 CM )47“75 ½ IN.(191.77 CM )54 5/16 IN.(137.95 CM )43 IN.(109.22 CM )12 ½ IN.(31.75 CM )VENTELECTRICALCONNECTIONW ATER INLETS(REAR)3 ¾ IN.(9.52 CM )9 3/8 IN.(23.81 CM )DRAIN OUTLET(REAR)5 ¼ IN.(13.33 CM )29 7/16 IN(74.77 CM )GAS SUPPLYPIPE (REAR)43 IN.(109.22 CM )41 ¼ IN(104.77 CM )36 1/16IN.(91.60 CM )1 7/8 IN.(4.76 CM )4 13/16 IN.(12.22 CM )11 7/16 IN.(29.5 CM )UNPACKING27 IN.(68.58CM)1. Using the four shipping carton corner posts (twoon each side), carefully lay the laundry center onits left side and remove foam shipping base.2. Using ratchet with 3/8 inch (0.96 cm) socket,remove mechanism shipping bolt and plasticspacer block from center of base.NOTE: If the laundry center is to be transportedat a later date, the tub blocking pad,shipping bolt, and plastic spacer blockshould be retained.3. Return laundry center to an upright position.PLASTIC SPACERBLOCK30 13/16 IN.(78.26 CM )4. Remove:(a) foam tub blocking pad.(b) foam shipping blocks from rear of unit.(c) tape from dryer door.(d) foam dryer support pads.(e) inlet hoses.(f) enclosure package.5. From the back of the washer, remove the wireshipping clips securing the drain hose and powercord (if equipped). Plastic clamps secure the drainhose to the right side of the washer backsheet.These clamps form a standpipe to prevent watersyphoning.DO NOT REMOVE THESE CLAMPS.6. Carefully move the laundry center to within 4 feet(1.22 m) of the final location to begin theinstallation.M ECHANISMSHIPPINGBOLTSHIPPING CARTON CORNER POSTSFOAMSHIPPINGPADDRAIN HOSEPOW ER CORD(IF EQUIPPED)44