SERVICE MANUAL - Appliance Blog

More documents

Recommendations

Info

5. If desired, add liquid bleach to Bleach Dispenser(some models).• Before adding the wash load, add liquid bleachto bleach dispenser located in left front cornerunder the lid:• 3/4 cup (180 ml) for small loads• 1 cup (240 ml) for large loads• 1-1/4 cups (300 ml) for extra-large loads.• Then add 1 cup (240 ml) water to flush thedispenser.• Do not use powdered bleach in the bleachdispenser.• Do not put items on top of agitator or wrap themaround it. Load items evenly.• Combine large and small items in a load. Loadlarge items first. Large items should not bemore than half the total wash load.• When washing a single heavy item, add 1 or 2towels to balance the load.7. If desired, add liquid fabric softener to FabricSoftener Dispenser (some models).For models with a built-in dispenser:For models without a bleach dispenser, dilutethe recommended amount of liquid chlorine bleachin 1 quart (.95 L) water. Add it to wash water aftera few minutes of agitation. Do not pour bleachdirectly on wash load.Built-In Fabric Softener Dispenser(some models)1. Add liquid softener to the dispenser, followingfabric softener label directions.2. Add water to bring liquid level to fill line ondispenser cap.Bleach Dispenser (some models)6. Add laundry load to washer.3. Remove the dispenser from the agitator aftereach use. Rinse both cap and cup with warmwater. Replace dispenser in the agitator.• Dry load level should not be higher than top rowof holes in wash tub.Do not overload washer.Built-In Fabric Softener Dispenser(some models)Do not load items abovetop row of holes in wash tub.NOTE: To separate cap from cup, put thumb intodispenser and push against side of cup (see pictureto the left). After cleaning, push cap and cup firmlytogether. Replace dispenser by lining up the ribsand grooves and snapping it into position.24
Fabric softener will be flushed from area under thebuilt-in fabric softener dispenser when Large LoadWater Level is selected. If a build-up of fabricsoftener occurs, clean with hot water. DO NOTREMOVE <strong>SERVICE</strong> CAP.For models with a removable dispenser1. Attach fabric softener dispenser to top of agitatorby pressing down gently.2. Add softener to the dispenser, following fabricsoftener label directions.• To stop the washer, push in the cycle selectorknob.• To change a cycle, push in the cycle selectorknob. Turn it clockwise to the desired setting.Pull out the knob to restart the washer.Removable Fabric Softener Dispenser(some models)3. Add water to bring liquid level to top of the pegin the center of the cup.4. Remove the dispenser from the agitator aftereach use. Rinse both lid and bowl thoroughlywith warm water. Reassemble and placedispenser on agitator or store it nearby.For models without a fabric softener dispenser,follow fabric softener label directions. Add dilutedfabric softener to the final rinse. Do not pour fabricsoftener directly on the wash load.8. Set cycle selector knob and washer controlsaccording to type, size, and soil level of eachload, and detergent used.See Operating Instructions for your specific modelcontrols.9. Start the washer.Close the washer lid and pull out the cycle selectorknob. Washer will fill with the lid open. The tub willnot agitate or spin unless the lid is closed.10. Remove items when the cycle is completed.For your safety, the lid locks when the tub isspinning. It will remain locked for about 1 minuteafter the tub stops spinning.• To open the lid during a spin, push in the cycleselector knob and wait about 1 minute for the lidlock to release. Do not force open the lockedlid.Place washed items in automatic dryer, line dry, ordry flat as directed by fabric care label. Excesswrinkling, color transfer or odors may develop initems left in the washer after the cycle has ended.To avoid serious personal injury, do notoperate washer if safety lid lock is missing or damaged.STAIN REMOVALSafe Stain Removal ProceduresTo reduce the risk of fire or seriousinjury to persons or property, comply with the basicwarnings listed below:• Read and comply with all instructions on stainremoval products.• Keep products in their original labeled containersand out of children's reach.• Thoroughly wash any utensil used.25
Page 1 and 2: (/(&752/8;Ã+20(Ã352'8&76Ã1257+Ã
Page 3 and 4: SAFE SERVICING PRACTICES 2QUICK REF
Page 5 and 6: Short unrestricted vents 51Electric
Page 7 and 8: Removing the control thermostat 101
Page 9 and 10: SpecificationsLAUNDRY CENTER WASHER
Page 11 and 12: Connecting Drive Motor for Bench Ch
Page 13 and 14: SAMPLE GAS DRYER SECTION WIRING DIA
Page 15 and 16: SAMPLE WASHER TIMER CYCLE CHARTCAM0
Page 17 and 18: The cycle signal will sound briefly
Page 19 and 20: • Prewash - When soaking is not n
Page 21: hydrogen gas. Hydrogen gas is flamm
Page 26 and 27: • Do not combine stain removal pr
Page 28 and 29: Common Washing ProblemsMany washing
Page 31 and 32: 4. Close the dryer door and set dry
Page 33 and 34: To reduce risk of fire or serious i
Page 35 and 36: Avoid Service ChecklistBefore calli
Page 37 and 38: OCCURRENCEDRYERDryer does not start
Page 39 and 40: SECTION C INSTALLATION INSTRUCTIONS
Page 41 and 42: :$51,1* Do not allow combustible ma
Page 43 and 44: 0 IN.(0 CM )0 IN.(0 CM )1 IN.(2.54
Page 45 and 46: ELECTRICAL INSTALLATIONALL ELECTRIC
Page 47 and 48: &$87,21DO NOT CROSS THREAD OROVERTI
Page 49 and 50: SECTION D - DRYER SECTION OPERA-TIO
Page 51 and 52: ing times, hotter dryer surfaces an
Page 53 and 54: the control thermostat are cycled b
Page 55 and 56: switch, so the switch can be releas
Page 57 and 58: SECTION E - WASHER SECTION OPERA-TI
Page 59 and 60: Softener Dispenser:The softener dis
Page 61 and 62: magnetic field pulls the armature u
Page 63 and 64: flushing the lint out the drain. Be
Page 65 and 66: ELECTRICAL OPERATIONIn the washer s
Page 67 and 68: Timer Motor CircuitPower is not sup
Page 69 and 70: Terminal M7 supplies power to the s
Page 71 and 72: Terminal M7 supplies power to the s
Page 73 and 74: SECTION F - TROUBLESHOOTING FLOW CH
Page 75 and 76:
Gas Dryer Completely Inoperative.No
Page 77 and 78:
Electric Dryers Timer Advances in A
Page 79 and 80:
Gas Dryers Blower Motor Runs but Dr
Page 81 and 82:
Washer SectionNOTE: Always check th
Page 83 and 84:
Washer Does Not Drain.Note: Always
Page 85 and 86:
Drive Motor Does Not Turn.Note: Alw
Page 87 and 88:
Slow Water Fill.Note: Always check
Page 89 and 90:
Washer will Not Fill in AnySetting
Page 91 and 92:
Water Temperature is too Hot or too
Page 93 and 94:
Removing the access panel:1. The ac
Page 95 and 96:
Removing the fabric selector switch
Page 97 and 98:
Removing the dryer door heat shield
Page 99 and 100:
Replacing the front duct:1. Disconn
Page 101 and 102:
Removing the control thermostat and
Page 103 and 104:
2. Disconnect the manual shut off,
Page 105 and 106:
Removing the high limit thermostat:
Page 107 and 108:
2. The blower wheel can be removed
Page 109 and 110:
3. Remove the three screw in the fr
Page 111 and 112:
2. Place a screwdriver between tran
Page 113 and 114:
Removing the water inlet nozzle:2.
Page 115 and 116:
3. Disconnect the wires from the ca
Page 117 and 118:
3. Remove the bolt from the front l
Page 119 and 120:
3. Using a 1/2” socket remove the
Page 121 and 122:
Removing the washer cabinet:1. Disc
Page 123 and 124:
NOTES123
show all

SERVICE MANUAL - Appliance Blog

Create successful ePaper yourself

Delete template?

Save as template?