S3.15 Strength System Base Owner's Manual - Precor

More documents

Recommendations

Info

S3.15 Assembly and Maintenance GuideD. Slide a Plastic Washer and a Roller Pad onto oneend of a Roller Pad Rod. Insert one MushroomCap to plug the end hole. If necessary, pound theMushroom Cap in place using the rubber mallet.E. Insert the Roller Pad Rod through the hole in theLeg Extension Arm.F. Slide the remaining Plastic Washer and Roller Padon the other end of the Roller Pad Rod. Insert oneMushroom Cap to plug the end hole. If necessary,pound the Mushroom Cap in place using therubber mallet.G. Attach the Floor Plate usingtwo ³⁄₄-inch buttonhead boltsWrench tighten using a 6mm hex key.DRollerPad RodPlastic WasherRoller PadMushroom CapFFloorPlateEG2 - ³⁄₄" buttonhead bolts1 2 3 4 5 6Step 3. Install Seat and Rollers, continuedpage 12
S3.15 Assembly and Maintenance Guide4. Assemble Weight StackImportant: Obtain adult assistance before installingthe Guide Rods and Weights.A. Place the Guide Rods into the two outside holes inthe Main Base.CAUTION: The lubricant on the Guide Rods canstain clothes. Wear proper attire when workingwith or lubricating the Guide Rods.B. Place one Guide Rod Spacer and one WeightCushion on each Guide Rod and allow it to slidedown and rest on the Main Base.Note: Guide Rod Spacers do not need to beinstalled if the Heavy Stack Option is purchasedthrough your dealer.C. Add the 10-lb weights. For ease of weight pinplacement and use, orient the curve on the weightplate to the desired side of the unit. Position theweight plate so the plastic bushing is on top andhold your finger over the plastic bushing to preventit from popping out.CAUTION: The weights are heavy! Handlethe weights carefully so as not to drop themor injure yourself. Pick up and place oneweight at a time on the Guide Rods. Do notangle the Guide Rods to such a degree thatthey dislodge the Guide Rod Spacers orWeight Cushions. Have someone hold theGuide Rods in place while you slide theweights on the stack.WeightCushionsBAGuide RodGuide Rod Spacers(Do not install spacers if youpurchased the Heavy Stack Option.)WeightC1 2 3 4 5 6Step 4. Assemble Weight Stackpage 13
Page 1 and 2: S3.15Strength-TrainingFitness Equip
Page 3 and 4: S3.15 Assembly and Maintenance Guid
Page 5: S3.15 Assembly and Maintenance Guid
Page 33 and 34: Precor Incorporated20031 142nd Aven
Page 36: S3.15 SpecificationsLength: 72 inch

S3.15 Strength System Base Owner's Manual - Precor

Create successful ePaper yourself

Delete template?

Save as template?