S3.15 Strength System Base Owner's Manual - Precor
S3.15 Strength System Base Owner's Manual - Precor
S3.15 Strength System Base Owner's Manual - Precor
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>S3.15</strong> Assembly and Maintenance Guide8. Install Leg Extension CableA. Before feeding the cable through the pulleyassemblies, remove the U-bracket assembly, cablestop ball and rubber washer at the end of the LegExtension Cable 130198.B. Start at the Pivoting Bracket attached to theMain <strong>Base</strong>. Feed the end of the cable beneath the3½-inch pulley.C. Feed the cable through the Single Floating Pulleyas shown.D. Disassemble the upper 3½-inch pulley locatedinside the Gusset which is welded to the <strong>Base</strong>Frame.E. Feed the cable under the lower pulley.F. Loop the cable over the upper 3½-inch pulley andsecure it to the Gusset usingone 2¼-inch bolttwo flat washersone locknutRubber WasherCable Stop BallU-bracketAGussetDC1 - 2¼" bolt2 - washers1 - locknutFEB1 2 3 4 5 6Step 8. Install Leg Extension Cablepage 20
Change language