S3.15 Strength System Base Owner's Manual - Precor

More documents

Recommendations

Info

<strong>S3.15</strong> Assembly and Maintenance GuideB. Slide the Handlebars in place on the Press Arm.Handlebars curve inward. Review the illustrationfor correct handlebar placement.C. Attach the Row Handles usingeight ¼ x ½-inch buttonhead screwseight radius washersNote: Make sure the radius washers lie flat againstthe Row Handle before wrench tightening.D. Wrench tighten the screws using the 5mm hexkeys.BPress Arm AssemblyHandlebarsRow HandlesC8 - ¼ x ½" buttonhead screws8 - radius washers1 2 3 4 5 6Step 5. Assemble Press Arm, continuedpage 16
<strong>S3.15</strong> Assembly and Maintenance Guide6. Install Main CableNote: All pulleys are installed in the frameassemblies. As you begin each new step, removethe fasteners and pulley. Feed the cable aroundthe pulley as shown, and then replace thefasteners and finger tighten. Wrench tighten allpulley fasteners once you have completed theinstallation of each cable assembly.A. Start at the Top Beam and feed the threaded endof Main Cable 130197 over one 4½-inch pulley.Attach the pulley to the Top Beam usingone 4-inch hex head bolttwo 1¹⁄₄-inch shoulder spacersone locknutB. Feed the cable over the second 4½-inch pulley.Attach the pulley to the Top Beam usingone 4-inch hex head bolttwo 1¹⁄₄-inch shoulder spacersone locknutC. Feed the cable over the upper 3½-inch pulleylocated in the Press Arm assembly. Attach thepulley to the Press Arm assembly usingone 2-inch zinc hex head bolttwo zinc flat washersone zinc locknutD. Feed the cable over the upper 3½-inch pulleylocated in the Main Upright. Attach the pulley to theMain Upright usingone 4-inch hex head bolttwo 1¹⁄₄-inch shoulder spacersone locknutPulley assemblies4½-inch Pulley1 - bolt2 - shoulder spacers1 - locknutCAB3½-inch Pulley (used on graypainted parts)1 - bolt2 - shoulder spacers1 - locknut3½-inch Pulley (used ontitanium parts)1 - zinc bolt2 - zinc washers1 - zinc locknutD3½-inch Pulley (used on graypainted parts)1 - bolt2 - washers1 - locknut1 2 3 4 5 6Step 6. Install Main Cablepage 17
Page 1 and 2: S3.15Strength-TrainingFitness Equip
Page 3 and 4: S3.15 Assembly and Maintenance Guid
Page 5: S3.15 Assembly and Maintenance Guid
Page 33 and 34: Precor Incorporated20031 142nd Aven
Page 36: S3.15 SpecificationsLength: 72 inch

S3.15 Strength System Base Owner's Manual - Precor

Create successful ePaper yourself

Delete template?

Save as template?