S3.15 Strength System Base Owner's Manual - Precor

More documents

Recommendations

Info

<strong>S3.15</strong> Assembly and Maintenance Guide2. Cable AdjustmentsYou may need to adjust the cables after installation andperiodically thereafter. If the cables remain slack afteryou have followed the steps found in Cable Tension,perform the following:A. Loosen the jam nut on the Weight Stack threadedend to expose additional threads. Adjust thethreaded end until the slack is removed.B. Loosen the jam nuts on the Floating Pulleysthreaded ends. Adjust the threaded ends until theslack is removed. Make sure the amount of threadsexposed on one pulley is about the same as theother pulley.C. Check the Top Cap Weight to make sure it remainswell-seated on the Weight Stack and then retightenthe jam nuts.D. Check the Selector Stem alignment by insertingthe Weight Pin into every hole on the Weight Stack.ThreadsJam NutATop CapWeightTop WeightCBJam NutTop Cap Weight is fullyseated on the top weight.No gap should appear.Thread exposure should remain thesame for both Floating Pulleys.12345D67891011121314151 2 3 4 5 6Cable Adjustments and Maintenance, continuedpage 28
<strong>S3.15</strong> Assembly and Maintenance Guide3. MaintenanceGuide RodsLubricate the Guide Rods every six months.InspectionInspect the unit daily.LubricantGuide RodLook and listen for loose fasteners, cable tensionissues, unusual noises and any other indications thatthe equipment may be in need of service.You are responsible for the proper maintenance of theunit as discussed in this manual. For other serviceissues, contact Customer Support. Refer to ObtainingService.1234567891011121314151 2 3 4 5 6Cable Adjustments and Maintenance, continuedpage 29
Page 1 and 2: S3.15Strength-TrainingFitness Equip
Page 3 and 4: S3.15 Assembly and Maintenance Guid
Page 5: S3.15 Assembly and Maintenance Guid
Page 33 and 34: Precor Incorporated20031 142nd Aven
Page 36: S3.15 SpecificationsLength: 72 inch

S3.15 Strength System Base Owner's Manual - Precor

Create successful ePaper yourself

Delete template?

Save as template?