Hexavalent Chromium ATCM for Decorative and Hard Chrome

Effective Date: October 24, 2007Appendix 2 - Content of Initial Compliance Status ReportsInitial compliance status reports required by subsection 93102.13(b) shall containthe following information:1. Company Information: Facility name, address, owner/operator name,telephone number, and the measured distance to the property boundary ofthe nearest sensitive receptor. For facilities that do not have an add-on airpollution control device the measurement shall be the distance, rounded tothe nearest foot, from the edge of the plating or anodizing tank nearest thesensitive receptor to the property line of the nearest sensitive receptor thatexists on October 24, 2007. For facilities with an add-on air pollution controldevice the measurement shall be the distance, rounded to the nearest foot,from the centroid of the stack to the property line of the nearest sensitivereceptor that exists on October 24, 2007;2. The applicable requirements from section 93102.4 and the methods thatwere used to determine compliance. A description of the air pollutioncontrol technique for each emission point;3. If a facility is using add-on controls to comply provide the following:a) Description of add-on controls and a performance test reportdocumenting the results of the performance test, which contains theelements listed in Appendix 1;b) If the facility is a hexavalent chromium facility, the actual hexavalentchromium emissions of the facility in pounds per year calculated bymultiplying the emission rate with the actual ampere-hours for thepreceding calendar year.c) For monitored parameters 93102.9(b) and (c), the specific operatingparameter value, or range of values, that corresponds to compliancewith the applicable emission limit; andd) A statement that the owner or operator has completed and has on filethe operation and maintenance plan as required by section 93102.11.4. If a facility is using in-tank controls to comply, provide the following:a) Description of in-tank controls including name of in tank controls, nameof chemical fume suppressant, surface tension of the electroplating oranodizing bath; and46