P3838_3 Mira Fino.pmd - QS Supplies

Section71. Before you complete the installation,determine whether the hot or cold waterservices will be connected to the showercontrol from the bottom (rising) or from thetop (falling).Before you decide on the final position ofyour shower control, please bear in mindthe following:Decide on a suitable position for the showercontrol. The position of the shower controland the shower fittings must provide aminimum gap of 25 mm between the spilloverlevel of the shower tray/bath and thehandset. This is to prevent backsiphonage.InstallationMira Fino Surface Mounted Shower ControlRising or Falling Inlet SuppliesNote! The Mira Fino is supplied with inletconnections hot left, cold right and bottomoutlet as standard. For installations withreversed hot and cold supplies refer to thesection Installation: "Reversed InletConnection".Falling SuppliesHose RetainingRingBackplateSpill-over LevelRising SuppliesGrubScrew25 mmMinimum2. Remove the backplate by releasing,anticlockwise, the two recessed grub screwswhich retain the backplate against the brassshower control body, using the 3 mm A/Fhexagon wrench (supplied).3. Use the installation template to mark thepositions of the fixing holes for the backplateon the wall.Ensure the holes are vertically aligned.Warning! Ensure there are no buried cablesor pipes in the wall before drilling.4. Drill the two marked fixing holes and fit thewallplugs provided. Secure the backplateto the wall with the two fixing screwsprovided.GrubScrewWallplugsBackplate14Note! Screws with larger heads will foul theshower control body.Fixing Screws