P3838_3 Mira Fino.pmd - QS Supplies

More documents

Recommendations

Info

19 Refit the three building-in shroud sectionsthat you removed earlier. Secure the shroudin position with the screws.FINISH20. Plaster and tile up to the tapered sides ofthe plastic building-in shroud and, whenset, remove the shroud. The two longershroud retaining screws should be kept foruse later.MAXMINMake sure that the finished tiled wall surfaceis within the FINISH arrow on the buildinginshroud.21. Apply a bead of silicone sealant betweenthe rubber seal and the tiled surface.Building-in ShroudSilicone SealantFinished SurfaceRubberSealRubber Cavity Seal22. Fit the back plate over the valve makingsure that the rubber seal is between theplate and the tiled surface. Secure the backplate in position with the three M5 x 60 mmfixing screws (supplied).Back PlateCaution! Make sure that you do notovertighten the screws.22
Flow lever23. Remove the temperature knob from theconcealing plate.Line up the flow lever with the top hub. To fitthe concealing plate, firstly clip it over the topof the back plate and then push it firmly untilit locates on the bottom.Align the temperature knob with the bottomhub and re-attach.24. This completes the installation of the <strong>Mira</strong><strong>Fino</strong> for installation into “Solid, Dry-lined,Stud Partition or Dry Partition WallStructures”.23
Page 1 and 2: SHOWER CONTROLInstallation &User Gu
Page 3 and 4: Section1 IntroductionThank you for
Page 5 and 6: 2. Mira Fino Built-in Shower Contro
Page 7 and 8: 5SPECIFICATIONSSpecificationsSectio
Page 9 and 10: Section6 Installation Requirements1
Page 11 and 12: Gravity fed showers - The shower co
Page 13 and 14: Pumped showers (inlet pumps)The sho
Page 15 and 16: 5. Install the inlet pipework.If ne
Page 17 and 18: Backplate5. Make good the wall surf
Page 19 and 20: 180 mm125 mm4. If installing the sh
Page 21: Compression NutOlive13. Stretch the
Page 25 and 26: Laminated Panels and Shower Enclosu
Page 27 and 28: Section8 Commissioning1. Maximum Te
Page 29 and 30: Temperature Override Button Disable
Page 31 and 32: Fino B1.1. Turn the flow lever anti
Page 33 and 34: Symptom6. Maximumblendtemperaturese
Page 35 and 36: 'C' WasherWave WasherHubTemperature
Page 37 and 38: Checkvalve/Strainer RenewalShould t
Page 39 and 40: Flow Cartridge RenewalShould the fl
Page 41 and 42: Section12Spare PartsMira Fino Spare
Page 43 and 44: Mira Fino B Spare Parts List451.01
Page 45 and 46: Notes45
Page 47 and 48: Notes47

P3838_3 Mira Fino.pmd - QS Supplies

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?