Operation instruction - Asennustuotteet

ABB i-bus ® KNXCommissioningNo. Function Object name Data type Flags10 Block Input A: 1 bitDPT 1.003C, WThis communication object is enabled if in parameter window A: Control scenethe parameter Enable communication object "Disable" 1 bit has been selected with option yes.Using the communication object Block, the input can be disabled or enabled. With activatedcommunication object Block, the inputs are disabled.NoteWhen the input is disabled, there is fundamentally no reaction to a signalchange, but:– Waiting for a long button operation or a minimum signaltime is suspended.– The parameter setting 8 bit scene is ended with saving.– Communication objects continue to be updated and sent if necessary.When enabling an input, a change of the signal states (as opposed to beforethe block) leads to immediate processing, e.g.:– The minimum actuation or detection of a long/short button push starts.– Communication objects send their current value if necessary.The communication object Block has no influence on manual operation. Thestatus of the simulated input signal continues to be sent here.Telegram value:0 = enable input A1 = disable input A11 Actuator groupInput A:variable C, W, TA[variable]Control sceneDPT variableDepending on the setting, this communication object sends the following values on the bus.1 bit value (ON/OFF)1 byte value [0…100]1 byte value [0…255]2 byte value [temperature]DPT 1.001 switch valueDPT 5.001 percentage valueDPT 5.010 counter valueDPT 9.001 temperature12 Actuator group B[variable]Input A:Control scenevariableDPT variableC, W, TDepending on the setting, this communication object sends the following values on the bus.1 bit value (ON/OFF)1 byte value [0…100]1 byte value [0…255]2 byte value [temperature]DPT 1.001 switch valueDPT 5.001 percentage valueDPT 5.010 counter valueDPT 9.001 temperature© 2011 ABB STOTZ-KONTAKT GmbH 102