Network Camera Server VB101

Log MessagesLog Messages●A033 Invalid file detected during picture index restoration (info)Message broken file detected: %1%1 File nameExplanation A file was detected during picture index restoration that is not a recorded picture.●P003 Memory card error (warning)Message AUTOMNT: cannot mount %1 on %2%1 Device name%2 Mount pointResponseDelete any invalid files. This does not affect picture index restoration processing.ExplanationMount processing was cancelled due to a memory card error.●A034 Recorded picture file read error during picture index restoration (info)ResponseReplace the memory card.Messagepicture file I/O error: %1●P004 Device busy (err)%1 File nameExplanationAn error occurred while a recorded picture file was being read during picture index restoration processing.MessageAUTOMNT: %1: device is busy%1 Device nameResponseCheck the contents of the file. This file is not included in the picture index.ExplanationThe card was unmounted during file access. This does not occur during normal operation.ResponseIf this occurred when administration tools were used to unmount the card, reboot.HTTP Server Log Messages●H011 File specification error (notice)Message HTTPD: File does not exist: %1%1 File nameExplanation The specified file was not found.●P005 Card initialization failed in card slot A (warning)Message ENABLER:slota enable errExplanation Card information read from the card inserted in card slot A failed.Response Re-insert the card or replace the card.●P006 Card initialization failed in card slot B (warning)ResponseMessageExplanationCheck the URL and file. (If the URL is "/opt/..." the file is on a memory card in "/card/htdocs/...).If the URL is not "/opt/...", the file is on the internal file system in "/htdocs/...".)If there is no error, the file system must be repaired.Card Slot-related Log Messages●P001 File system mounting failure (warning)AUTOMNT: %1 already mounted or %2 busy%1 Device name%2 Mount pointResponseMessageExplanationTwo memory cards are inserted together or the memory card cannot be mountedbecause an error occurred when it was last unmounted.If the card cannot be mounted because an error occurred when it was last unmounted, reboot.●P002 Mount number exceeded (err)ResponseAUTOMNT: mount table fullThe mount entry table is full.This can occur when unmount errors are repeated.Reboot.96 97MessageExplanationResponseMessage%1ENABLER:slotb enable errCard information read from the card inserted in PCMCIA slot B failed.Re-insert the card or replace the card.●P009 Memory card read error (err)PCMCIA ATA Card(Slot%1 sector %2): Read Sector ErrorSlot (A|B)%2 Sector numberExplanationResponseMessage%1A sector read error occurred. The card may be damaged.Check the memory card and, if necessary, reformat the card.If there is a physical fault on the card, replace the card.●P010 Memory card write error (err)PCMCIA ATA Card(Slot%1 sector %2): Write Sector ErrorSlot (A|B)%2 Sector numberExplanationResponseA sector write error occurred. The card may be damaged.Check the memory card and, if necessary, reformat the card.If there is a physical fault on the card, replace the card.6Troubleshooting