XE-A303 Operation-Manual GB - Sharp

Part3 FOR THE MANAGERPRIOR TO PROGRAMMINGProcedure for programming1. Check to see whether both journal and receipt rolls are present in the machine. Ifthere is not enough paper on a roll, replace it with a new one (refer to "Replacingthe Paper Roll" on page 95 for the replacement).2. Put the manager key in the mode switch and turn it to the PGM position.3. Program necessary items into the cash register.REGOPX/ZEvery time you program an item, the cash register will print the setting. Please refer to print samples in eachsection.4. If necessary, issue programming reports for your reference.• On the key operation example shown in the programming details, numbers such as “22082007”indicates the parameter which must be entered using the corresponding numeric keys.• Asterisks in the tables shown in the programming details indicate default settings.PGMMGRX1/Z1X2/Z2Guidance messagesDepending on programming items, the register shows guidance messages on the operator display to indicate aprogramming item you are in, or guidance to enter data, as shown in the examples below.Your register allows you to program all necessary data in one procedure with the guidance messages fordepartment programming (page 16), PLU (Price Look-Up) and subdepartment programming (page 22),programming for the -, %, &, V, r, R, X, Y, c and b keys (pages 52-62). For their guidancemessages, please refer to each section.Example 1: For key entry type programmingKey operation exampleParameter/price entryPress of the subjected key• Guidance message is displayed.To terminate008 @(In case of parameter entry)sAPGM008PAYMENT KEY PROG0.00Operator displayPGM0.00To repeat(depending on programming)Guidance message is keptdisplaying until you pressthe A key.49