Pulse XT 25e Manual - E-flite
Pulse XT 25e Manual - E-flite
Pulse XT 25e Manual - E-flite
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Ο 2. Using a 3/32” balldriver, install the motor on the firewall with four 4-40x 1/2" socket head bolts. The motor wires should exit towards the bottom ofthe fuselage. You may use threadlock to prevent these screws from vibratingloose in flight.Ο 4. Install the battery with two hook and loop straps. Slots are provided onthe floor of the battery compartment for the straps to pass through. The naturalcurl of the straps will allow them to be fed down one slot, under the batterycompartment floor, then up through the opposite slot.Ο 3. Remove the battery hatch by sliding it forward to disengage the magnets,and lifting at the rear. It can then be pulled rearwards and off the model.Ο 5. Install the ESC on the right-hand side of the battery compartment withhook and loop tape. The battery leads, switch leads and throttle leads will betowards the rear of the model. Connect the ESC to the motor.12