Pulse XT 25e Manual - E-flite

Ο Ο 4. Use a file or rotary tool to make a 1/4” wide flat on the top of each ofthe four axles. The flat should be located approximately 9/16” (14mm)outboard of the hexagonal axle base.Ο Ο 5. Attach the floats using four 5/32” wheel collars and four 3mmsetscrews using the 1.5mm Allen wrench provided in the float kit. Make sure touse threadlock when installing the setscrews in the flats made previously.Note: One of the floats has holes drilled in the aft end for the water rudderbracket. This float will get mounted on the left side of your Pulse XT 25e.Ο 6. Attach a nylon bracket to the aft end of the left float with four 3mm x12mm sheet metal screws. Using a drill and 11/64 in (4.5mm) drill bit,enlarge the hole through the mounting bracket.24