Pulse XT 25e Manual - E-flite

Ο 2. A string is provided in each wing half to draw the aileron lead throughthe wing. Attach the end of the string to the aileron servo lead and pull itcarefully through the wing to the center. Once both leads have been pulledthrough, they can be secured to each other with tape to prevent them fallingback into the wing.Ο Ο 4. Using a 1/16 in (1.5mm) drill bit in a pin drill, drill the four mountingholes for each aileron servo. After drilling, apply a small drop of thin CA toeach hole to strengthen the wood.Ο Ο 3. Place the servos in the wing openings and mark the screw holelocations with a felt-tip pen.Ο Ο 5. Using a #0 Philips screwdriver, and the screws provided with theservos, install the aileron servos with the output shaft towards the trailing edgeof the wing.20