Pulse XT 25e Manual - E-flite

Required PartsFuselageCanopyCooling Exit ScoopCanopy and Cooling Exit ScoopΟ 2. Follow the same procedure to attach the cooling exit scoop on the lowerfuselage behind the wing in the location shown. Note that the opening facestowards the rear of the model.Required Tools and AdhesivesLow-tack tapeCanopy GlueΟ 1. Trial fit the canopy on the fuselage. Once satisfied with its location, applyglue to the inside of the canopy at the areas of the painted frame, and installon the fuselage. Tape can be used to hold it in place while the glue dries.Allow the glue to dry completely before removing the tape.Note: If you opt to fly from land please proceed to the Flight Preparationsection on page 27. If you are installing floats, please proceed to the nextpage.22