Pulse XT 25e Manual - E-flite

Ο 4. Apply low-tack tape to the upper and lower surfaces of the center of thewing panels as shown. This will allow for easy clean up of any excess glue andmake for a clean joint.Ο 6. 12-minute epoxy is used to install the dihedral joiners and join the wing.Glue the two dihedral joiners to each other.Ο 5. Apply a piece of clear tape to the front and rear wing saddle area wherethe wing leading and trailing edges will come in contact with the fuselage.Ο 7. Using a mixing stick, apply epoxy to the dihedral joiner slot in each wingpanel, and to the exposed root rib of one wing panel.18