Pulse XT 25e Manual - E-flite

More documents

Recommendations

Info

Ο 4. Install the spinner cone using a #1 Philips screwdriver and the suppliedPhilips head screws.An alternate method to drilling completely through thespinner backplate is to grind only the relief necessary toclear the propeller adapter hub.This can be done by handusing a straight cutter in a Dremel rotary tool. Theremainder of the hole can be left at its orginal size and willbe a good fit on the propeller shaft.16
Wing JoiningRequired PartsWing halves (L and R)(2) dihedral joiners(2) leading edge dowels(2) 6-32 x 1” socket head bolts(2) #6 steel washersΟ Ο 2.. Upon installation, approximately 5/16” to 3/8” of the dowel shouldprotrude from the leading edge of the wing.Required Tools and AdhesivesLow-tack tape12-minute epoxyClear tape7/64” balldriverMixing cupsMixing sticksRubbing alcoholPaper towelsΟ Ο 1. Install the leading edge dowels in the wing panels with 12-minuteepoxy. Use paper towels and rubbing alcohol to clean any epoxy thatsqueezes out onto the wing.Ο Ο 3. The rear side of the dowel is accessible through the wing root rib and asmall amount of epoxy can be added here to secure its installation.17
Page 1: WeihnachtsfeierZur diesjährigen We
Page 5 and 6: Landing Gear Assembly and Installat
Page 7 and 8: Required PartsFuselageVertical stab
Page 9 and 10: Ο Ο 4. Remove the servo arm using
Page 11 and 12: Receiver InstallationRequired Parts
Page 13 and 14: Motor and Battery InstallationE-fli
Page 15: Cowling, Propeller and Spinner Inst
Page 19 and 20: Ο 8. Install the dihedral joiners
Page 21 and 22: Ο Ο 6. Using a #1 Philips screwdr
Page 23 and 24: Optional Float Installation.Require
Page 25 and 26: Ο 7. Install the rudder assembly,
Page 27 and 28: Flight PreparationControl Direction
Page 29 and 30: 25-Size Float SetOptional ItemsE-fl
Page 31 and 32: Lithium Polymer Battery Pack Inform
Page 33 and 34: AMA National Model Aircraft Safety
Page 35 and 36: Inspection or RepairsIf this Produc

Pulse XT 25e Manual - E-flite

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?