Emotron FDU 2.0 AC drive

2.2 Stand-alone unitsThe AC drive must be mounted in a vertical position againsta flat surface. Use the template (delivered together with theAC drive) to mark out the position of the fixing holes.2.2.2 Mounting schemes128.5 3710Ø13 (2x)416396Fig. 4 AC drive mounting model 003 to 1500202.6Ø7 (4x)2.2.1 CoolingFig. 4 shows the minimum free space required around theAC drive for the models 003 to 1500 in order to guaranteeadequate cooling. Because the fans blow the air from thebottom to the top it is advisable not to position an air inletimmediately above an air outlet.Fig. 5GlandsM20FDU48/52: Model 003 to 018 (B)GlandM16The following minimum separation between two AC drives,or a AC drive and a non-dissipating wall must bemaintained. Valid if free space on opposite side.Table 4FDU-FDU(mm)FDU-wall,wall-oneside(mm)Mounting and cooling003-018 026-074 090-250 300-1500cabineta 200 200 200 100b 200 200 200 0c 0 0 0 0d 0 0 0 0a 100 100 100 100b 100 100 100 0c 0 0 0 0d 0 0 0 0Fig. 6GlandsM32GlandM25Cable interface for mains, motor and communication,FDU48/52:Model 003 to 018 (B)NOTE: When a 300 to 1500 model is placed between twowalls, a minimum distance at each side of 200 mm mustbe maintained.Fig. 7FDU48/52: Model 003 to 018 (B), with optionalgland plate10 Mounting Emotron AB 01-4428-01r3