ODU MAC

Technical InformationExplanations of voltage information in compliance with MIL:Standards applied:SAE AS 13441-method 3001.1MIL-Std 1344-method 3001IEC 60512-2, Test 4aGeneral information:The values according to SAE AS 13441-method 3001.1 correspond to those of MIL-Std 1344- method 3001. The specifiedvalues were determined in accordance with IEC 60512-2, Test 4a.Each insert was tested when inserted, whereby the test voltage was applied to the male insert.All tests were conducted at normal room climate and are valid to an altitude of 2000 meters.If there are deviations, the reduction factors according to the relevant standards should be taken into consideration.Test Voltage:The test voltage is defined as 75% of the disruptive discharge voltage established according to the standard.➜ Test Voltage = disruptive discharge voltage x 0,75Operating voltage:According to the standard, the operating voltage is defined as 1/3 of the established test voltage.➜Operating voltage = disruptive discharge voltage x 0,75 x 0.33Please note:For some applications, the safety requirements for electric devices are very strict with regard to the operating voltage. Inthese cases, the operating voltage is correspondingly defined according to the clearance and creepage distances betweenexposed parts. When making a selection for these connectors, please contact us and tell us the safety standard with whichthe product must comply.ODU Steckverbindungssysteme GmbH & Co. KG, Pregelstr. 11, D-84453 Mühldorf/Inn, Tel. +49/86 31/61 56-0, Fax +49/86 31/61 56 49, www.odu.de Page 59