Manual optoNCDT ILR 1181-1182 - Micro-Epsilon

Control Commands10.05 (.396)10.00 (.393)9.95 (.392)9.90 (.39)9.85 (.388)9.80 (.386)9.75 (.384)9.70 (.382)9.85(.388)9.83 (.387) x9.88(.389)10 (.393)9.89(.389)9.85(.388)9.86x (.388)Ist-Measurement Korr. run Limit9.88(.389)2y9.77(.385)9.75 (.384)z1 2 3 4 5 6 7 8 9 10Fig. 22 Correction of measuring value7.3.13 TDxy......Display/Set Trigger Delay, Trigger LevelStandard setting: 0 0TD sets up solely the behavioral configuration of the remote trigger input (DF mode, see Chap. 7.2.5).TD consists of two parameters which are separated by space (20 hex):-- the delay time, and-- trigger flange.XYcorresponds to the delay in time from the arrival of a trigger signal to the start of a measurement.Delay settings may range from 0 to 9999 ms.0 for HIGH > LOW transition1 for LOW > HIGH transitionoptoNCDT ILR 1181 / 1182Page 36