Fusion FH-100 and FHR-100 - Vinten Radamec

More documents

Recommendations

Info

Fusion FH-100 and FHR-100 pan and tilt heads Connecting the Fusion head to an FBH-175 height drive When a Fusion FH-100 or FHR-100 head is mounted onto a manual only pedestal, a Fusion bolton height drive (FBH-175) can be installed to remotely operate the elevation of the pedestal from a Vinten Radamec control panel. The power and Ethernet connections from the Fusion height drive to the head are shown in Fig. 9. Head Ethernet The height drive has two power output sockets and a single power inlet socket that is connected to the studio supply. The Head Power Output socket is used to supply power to the head. Note that the Head Power Output socket is controlled by the height drive and therefore it is switched, fused and isolated on activation of the Emergency Stop button on the height drive. Each power connector on the height drive is fitted with a retaining clip to prevent the cable becoming dislodged causing accidental loss of power. Always ensure that the retaining clip is fastened. Ethernet connection to the head is supplied by the Ethernet OUT port on the FBH-175 height drive. The Ethernet IN port connects to the Vinten Radamec control panel via the Ethernet node. The height drive is supplied with a head communication cable that can be used to connect the height drive to the head. 22 Head power output socket Head communication cable Fig. 9 Fusion FBH-175 height-drive-to-head power and Ethernet connections
Camera lens cabling Operators guide The head has an integral lens drive capability that can directly drive any full-servo digital Canon or Fujinon broadcast lens. A lens cable to suit a Canon or Fujinon lens can be supplied to connect the camera lens to the head. A digital camera lens requires a single RS232 focus and zoom cable connected from the lens to the Focus/Digital port on the head. Analogue lenses require separate zoom and focus cables to be connected from the lens to the head. The analogue lens zoom cable connects to the Zoom port and the analogue lens focus cable to the Focus/Digital port on the head. NOTE: 1. A digital lens may have analogue zoom and focus hand controls connected simultaneously with a RS232 digital zoom/focus cable. However, the analogue hand controls will not function until the digital cable connection is removed, either at the head or the lens. 2. A separate hand-control unit (HCI) is available to automate the switching of camera lens control (Canon or Fujinon) between robotic lens control and manual hand controls— depending on the operating mode of the robotic head. Connecting to the Fusion Hand Control Interface (HCI) The Fusion Hand Control Interface (HCI) is mounted on to the underside of the camera cradle and is supplied with a single zoom/focus control cable that provides connection between the head Zoom and Focus/Digital ports and the Zoom/Focus control input port on the HCI unit. The unit is also supplied with the appropriate cables for connection to the pan bar-mounted hand controls and camera lens. Fig. 10 below shows the connection between the Vinten Radamec Fusion HCI and the head. Fig. 10 Fusion HCI-to-head lens ports connection 23
Page 1: Fusion FH-100 / FHR-100 Pan and Til
Page 4 and 5: Publication Part No. V3979-4980 Iss
Page 6 and 7: Fusion FH-100 and FHR-100 pan and t
Page 42: Fusion FH-100 and FHR-100 pan and t

Fusion FH-100 and FHR-100 - Vinten Radamec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?