Fusion FH-100 and FHR-100 - Vinten Radamec
Fusion FH-100 and FHR-100 - Vinten Radamec
Fusion FH-100 and FHR-100 - Vinten Radamec
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Switching the <strong>FH</strong>-<strong>100</strong> head to manual mode<br />
Operators guide<br />
WARNING!<br />
The <strong>FH</strong>-<strong>100</strong> head can be operated remotely from a control panel.<br />
Ensure that the control panel operator does not attempt to select the<br />
camera whilst a camera operator is operating the head manually!<br />
The head can be operated manually by a camera operator using the pan bars to control pan <strong>and</strong><br />
tilt movements. H<strong>and</strong> controls can be fitted to the pan bar h<strong>and</strong>les to control the camera lens<br />
<strong>and</strong> an additional h<strong>and</strong>-control unit may be installed to automate switching between remote <strong>and</strong><br />
manual lens controls.<br />
NOTE: The head must be rebalanced whenever equipment is removed or added, or the<br />
pan bar h<strong>and</strong>les are adjusted (see Balancing the head <strong>and</strong> payload on page 25).<br />
Manual mode disengages the robotic drives <strong>and</strong> engages the drag modules. Pan <strong>and</strong> tilt axes<br />
can be independently set to manual (MAN) mode by turning the relevant pan or tilt rotary switch<br />
fully clockwise, <strong>and</strong> then rotating the axis until the drag module engages (Fig. 18).<br />
Fig. 18 Setting the <strong>FH</strong>-<strong>100</strong> pan <strong>and</strong> tilt head manual mode<br />
33
Change language