Fusion FH-100 and FHR-100 - Vinten Radamec

More documents

Recommendations

Info

Fusion FH-100 and FHR-100 pan and tilt heads To switch the FH-100 VR head from VR manual to robotic mode: 36 1. Set the VR Mode switch [8] on the back of the FH-100 VR to AUTO. The LED on the switch extinguishes. 2. Enable the head from the control panel to initialise robotic control. Switching the FH-100 VR head to full manual mode The FH-100 VR can be switched to full manual mode, disengaging the robotic drive and encoders and engaging the drag modules, by turning the rotary switches to the MAN position (see Switching the FH-100 head to manual mode on page 33). The pan and tilt drag units can also be adjusted (see Adjusting the pan and tilt drag on page 34).
Maintenance Checking balance Operators guide It is recommended that the balance of the head is checked at least once a month to ensure proper operation and to reduce excessive wear on the drive train and potential overheating. An unbalanced load may also affect servo operation and responsiveness. Unless the mounting screws are loose, the balance should only change when the camera is moved back and forth, or if the payload has been changed. Routine checks During use, check the following: • Check the data communication with the control panel. Refit cables if necessary. • Check lens zoom and focus communication with the Head. Refit cables if necessary. • Once a month check the balance of the head (see ‘Checking balance’ above). Rebalance as necessary. No further routine maintenance is required. Cleaning WARNING! ELECTRIC SHOCK Do not remove the cover. No user-serviceable parts inside. Refer to qualified service personnel. We encourage regular cleaning of the product. During normal use the only cleaning required should be a regular wipe over with a lint-free cloth. Cover the head when not in use. Dirt accumulated during storage or periods of non-use may be removed with a vacuum cleaner. Particular attention should be paid to the four-hole mounting and camera mounting faces, along with all the connection ports. CAUTION! 1. Do not use oil or grease on any exposed part of the product. This is unnecessary and traps dirt which acts as an abrasive. 2. Do not use solvent- or oil-based cleaners, abrasives or wire brushes to remove accumulations of dirt as these damage the protective surfaces. To clean mechanical surfaces, use only detergent-based cleaners. 3. External electrical connection ports should only be cleaned with a vacuum cleaner. 37
Page 1: Fusion FH-100 / FHR-100 Pan and Til
Page 4 and 5: Publication Part No. V3979-4980 Iss
Page 6 and 7: Fusion FH-100 and FHR-100 pan and t
Page 42: Fusion FH-100 and FHR-100 pan and t

Fusion FH-100 and FHR-100 - Vinten Radamec

Create successful ePaper yourself

Delete template?

Save as template?