Fusion FH-100 and FHR-100 - Vinten Radamec

More documents

Recommendations

Info

Fusion FH-100 and FHR-100 pan and tilt heads 32 Pan right Zero pan Pan left Move joystick to the right to pan right Move joystick forward to tilt the camera downward Fig. 16 Controlling pan movements using the joystick Move joystick backward to tilt the camera upward Fig. 17 Controlling tilt movements using the joystick Move joystick to the left to pan left
Switching the FH-100 head to manual mode Operators guide WARNING! The FH-100 head can be operated remotely from a control panel. Ensure that the control panel operator does not attempt to select the camera whilst a camera operator is operating the head manually! The head can be operated manually by a camera operator using the pan bars to control pan and tilt movements. Hand controls can be fitted to the pan bar handles to control the camera lens and an additional hand-control unit may be installed to automate switching between remote and manual lens controls. NOTE: The head must be rebalanced whenever equipment is removed or added, or the pan bar handles are adjusted (see Balancing the head and payload on page 25). Manual mode disengages the robotic drives and engages the drag modules. Pan and tilt axes can be independently set to manual (MAN) mode by turning the relevant pan or tilt rotary switch fully clockwise, and then rotating the axis until the drag module engages (Fig. 18). Fig. 18 Setting the FH-100 pan and tilt head manual mode 33
Page 1: Fusion FH-100 / FHR-100 Pan and Til
Page 4 and 5: Publication Part No. V3979-4980 Iss
Page 6 and 7: Fusion FH-100 and FHR-100 pan and t
Page 42: Fusion FH-100 and FHR-100 pan and t

Fusion FH-100 and FHR-100 - Vinten Radamec

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?