Intel(R) 80219 General Purpose PCI Processor Evaluation Platform ...

Intel® IQ80219 General Purpose PCI Processor Evaluation PlatformGetting Started and DebuggerB.7 Running the Code|Lab DebuggerThis section is provided to get the system up and running in the Code|Lab Debug environment, but itis not intended as a full-functional tutorial. Please refer to the ATI Code|Lab Debug ReferenceManual for more detailed information.B.7.1Launching and Configuring Debugger1. In EDE, click on the icon that looks like a red bug.a. The “Connect” dialog appears.2. When not configured from Section B.4.2, “Using Flash Programmer”, go to Section B.4.2 andperform steps 2-5.3. When running version 1.5 of the Code|Lab Debugger or earlier, a script must be specifiedunder the “Configure Macraigor JTAG Connection” Window:a. Check the Script Options boxb. hit Browsec. then locate the following:”C:\Ati\boards\IQ80321\Plus\Demo\Init_IQ80321.vbs”d. hit OKNote:Note:This script adds delay between the JTAG initialization and the launching of RedBoot so that theboot is successful after hitting Go.4. Press Connect to enter debug mode.a. The Code|Lab Debug environment appears with the Assembly window open.Mouseovers are available for most of the toolbar icons. (Leave the mouse over the debug iconsacross the top on the toolbar to see a brief explanation of each.)5. Click on the go icon and let RedBoot boot (takes a minute) until you get the RedBootprompt “RedBoot>” in the Console window (click the Console tab at the bottom of the Debugwindow to view the Console window).6. From the console window:a. type “diag”.b. hit “Enter”.The RedBoot Diagnostic function is invoked.Try out a few of the tests as desired.7. Close the Debugger and EDE environment.8. Reset the board (cycle power).96 Board Manual