Kantech IP Link Installation Manual - Tyco Security Products

More documents

Recommendations

Info

WAN ConfigurationsWhen sites are distant from each other and protected by the router’s firewall, the public IP addressmust be used for communication between EntraPass and the remote IP Link. The NetworkAdministrator must provide you the Public IP addresses (local and remote). The public IP address isprovided by the local Internet Service Provider (ISP) which controls the IP address.Note: Kantech recommends the use of a Static or Reserved DHCP IP address for the remote IP Linkand the Gateway since the routers must be configured for port forwarding.There are two WAN configurations for the IP Link:Static IP AddressingYou will use this type of addressing in an environment where the Network Administrator will determinethe IP address for communication between EntraPass and the IP Link. Since the EntraPass applicationis at the host site, you must use the KT-Finder to configure the IP Link.8DN1670-0706
IP Link Installation ManualReserved DHCP IP AddressingYou will use this type of addressing in an environment where the customer DHCP server assigns theIP address automatically to the IP Link. Since the EntraPass application is at the host site, you mustuse the KT-Finder to configure the IP Link.Pre-InstallationIt is important at this stage, if you have not already done so, to contact the Network Administratorwhere the IP Link will be installed so that you can complete the Network Configuration InformationSheet. We suggest that you always have the Network Configuration Information Sheet close by, andkeep a copy with your IP Link.Confirm that all parts are in order, all necessary tools are available, and that the site is properlyprepared.If you are connecting your IP Link to EntraPass, you must make sure that you are running EntraPassv4.0 or higher.NetworkConfiguration• Network Configuration Information Sheet is fully completedEquipmentChecklist• IP Link• RS-232 cabling• Installation Manual• VC-485 (recommended)• Network cable• Network crossover cable for direct connection from PC to IP LinkESDPrecautionsElectroStatic Discharge (ESD) can damage electrostatic sensitive devices. Use antistatic protection toavoid the risk of equipment damage.DN1670-0706 9
Page 1: Kantech IP LinkEnhanced Ethernet De
Page 4 and 5: General InformationCopyright Info©
Page 6 and 7: Cover DescriptionThe IP Link has a
Page 8 and 9: Ordering InformationModels Availabl
Page 12 and 13: ReadingChecklistWe strongly suggest
Page 14 and 15: 3- Connecting the IP Link to the Co
Page 16 and 17: 5- Powering Up the IP Link1. Power
Page 18 and 19: 6- Defining the EntraPass Site (con
Page 20 and 21: 8- Configuring the IP Link in a WAN
Page 22 and 23: 8- Configuring the IP Link in a WAN
Page 24 and 25: Configuring the IP Link with the We
Page 26 and 27: Upgrading the IP Link Firmware (con
Page 28 and 29: How to Reset the IP LinkFor mainten
Page 30: Kantech IP Link Enhanced Ethernet D

Kantech IP Link Installation Manual - Tyco Security Products

Create successful ePaper yourself

Delete template?

Save as template?