NV9 USB manual set - cover sheet - Sensis

NV9 USB Manual Set – Section 5 17Action Command Code (Hex) Command SetNote cleared into cash box atresetNote path openChannel Disable0xE2, Channel Number0xE00xB5ValidatorNotes:ActionCommentsCommand Not Known: Returned when an invalid command is received by aperipheral.Wrong Number OfParameters:A command was received by a peripheral, but an incorrectnumber of parameters were received.Parameter Out OfRange:Command Cannot BeProcessed:Software Error:Key Not Set:Jammed:One of the parameters sent with a command is out ofrange.A command sent could not be processed at that time –this will return a corresponding error code.Reported for errors in the execution of software e.g.Divide by zero. This may also be reported if there is aproblem resulting from a failed remote firmware upgrade,in this case the firmware upgrade should be redoneThe slave is in encrypted communication mode but theencryption keys have not been negotiatedFive-byte response that indicates that the validator isjammed; this is reported until it is un-jammed or reset. Itwill also become disabled.Copyright © Innovative Technology Ltd 2012GA550-2