NV9 USB manual set - cover sheet - Sensis

NV9 USB Manual Set – Section 6 11APPENDIX E – CONFIGURATION CARDPlease consult ITL technical document GA959 for further information on configurationcard programming – the GA959 document includes a printable template for theconfiguration card and this can be downloaded from the Support section of the ITLwebsite – the sample shown here should not be used for programming as itis not to scale.Configuration Card - instructionsfor use:1. Cut card around the outline -check the measurements are asprinted. Make sure that ‘Pagescaling’ is set to ‘None’ in yourprint options to ensure thecorrect size.2. Fill in sections as required. Takecare to fill in the sectionscorrectly, keep inside the linesand fill boxes fully as shownhere:3. Power-up the validator and waituntil it resets.4. Press the configuration buttononce to enter programmingmode (the bezel LEDs shouldflash at 1 second intervals).5. Insert the card into the validatorface up and in the directionindicated by the arrows.6. The configuration card will beejected and if the configurationwas good the bezel LEDs willflash at a fast rate whileprogramming takes place. Aftercompletion of programming thevalidator will reset.Copyright © Innovative Technology Ltd 2012GA550-2