INSTRUCTION MANUAL - Alessandri srl

More documents

Recommendations

Info

5. MAINTENANCE ––––– 75In early period of use, the engine oil gets dirty rapidlybecause of the initial wear of internal parts. Replace theengine oil earlier.Engine oil filter should also be replaced when the engineoil is replaced.Engine oil and engine oil filter replacing procedures are asfollows.Remove the oil filler cap to drain easily while drainig theengine oil.1) Prepare a waste oil container collecting waste oil.2) Loosen the drain plug using a wrench (customer procured)to drain the engine oil.3) Securely tighten the drain plug after draining the engineoil.4) Turn the engine oil filter counter-clockwise using a filterwrench (customer procured) to remove it.5) Clean the engine oil filter mounting face.6) Moisten the new engine oil filter gasket with the engineoil and install the new engine oil filter manually turningit clockwise until it comes into contact with the mountingsurface, and tighten it further to 3/4 of a turn withthe filter wrench.Tightening torque: 20∼24N•m (2.0∼2.4kgf•m)The location depends on the engineinstalled on the machine unitDipstickOil panDrain plug
76 ––––– 5. MAINTENANCE7) Fill with the new engine oil until it reaches the specifiedlevel as explained in section 3.3.IMPORTANT:Do not overfill the oil pan with engine oil.Be sure to keep the specified level betweenupper and lower limit on the dipstick.8) Warm up the engine by running for 5 minutes whilechecking any oil leakage. (Refer to 4.3.2 Warming uprunning)9) Stop the engine after warming up and leave it stoppingfor about 10 minute to recheck the engine oil level withdipstick and replenish the engine oil. If any oil isspilled, wipe it away with a clean cloth.LoosenTightenEngine oil filter
Page 2:
FOREWORDThe ISUZU industrial diesel
Page 6 and 7:
The EPA (U.S. Federal) and Air Reso
Page 8 and 9:
• Engine family name as assigned
Page 10 and 11:
Réglementations sur les moteurs à
Page 12 and 13:
• Nom de famille du moteur tel qu
Page 14 and 15:
Requirements on engine installation
Page 16 and 17:
Maintenance scheduleTo maintain opt
Page 19 and 20:
Calendrier de maintenancePour maint
Page 21 and 22:
This emission warranty does not cov
Page 23 and 24:
La garantie concernant les émissio
Page 25 and 26:
• Label location:Emission control
Page 27:
3.2.2 Priming the fuel system . . .
Page 31 and 32:
2 ----- 1. FOR YOUR SAFETY• The f
Page 33:
4 ----- 1. FOR YOUR SAFETYPreventin
Page 36 and 37:
1. FOR YOUR SAFETY ----- 7Well fitt
Page 40 and 41:
1. FOR YOUR SAFETY ----- 11IMPORTAN
Page 42 and 43:
1. FOR YOUR SAFETY ----- 13• It i
Page 44 and 45:
2. PRODUCT OVERVIEW2. PRODUCT OVERV
Page 46 and 47:
2.2 Names of parts2. PRODUCT OVERVI
Page 48 and 49:
2. PRODUCT OVERVIEW ----- 192.3 Fun
Page 50 and 51:
2. PRODUCT OVERVIEW ----- 212.4 Con
Page 52 and 53:
2. PRODUCT OVERVIEW ----- 232.4.2 O
Page 54 and 55: 2. PRODUCT OVERVIEW ----- 25(3) Gov
Page 56 and 57: 3. BEFORE YOU OPERATE3. BEFORE YOU
Page 59 and 60: 30 ----- 3. BEFORE YOU OPERATEPreca
Page 61 and 62: 32 ----- 3. BEFORE YOU OPERATE3.1.2
Page 63 and 64: 34 ----- 3. BEFORE YOU OPERATE(3) H
Page 65 and 66: 36 ----- 3. BEFORE YOU OPERATE3.2 S
Page 67 and 68: 38 ----- 3. BEFORE YOU OPERATE3.2.2
Page 73 and 74: 44 ----- 3. BEFORE YOU OPERATE• D
Page 75 and 76: 46 ----- 3. BEFORE YOU OPERATE
Page 77 and 78: 48 ----- 4. OPERATION INSTRUCTIONSP
Page 79 and 80: 50 ----- 4. OPERATION INSTRUCTIONS4
Page 81 and 82: 52 ----- 4. OPERATION INSTRUCTIONSI
Page 83 and 84: 54 ----- 4. OPERATION INSTRUCTIONSF
Page 97 and 98: 68 ----- 4. OPERATION INSTRUCTIONS
Page 99 and 100: 70 ----- 5. MAINTENANCEHave a set o
Page 101 and 102: 72 ----- 5. MAINTENANCEPeriodic ins
Page 103: 74 ----- 5. MAINTENANCE5.3 Periodic
Page 107 and 108: 78 ----- 5. MAINTENANCE2) If necess
Page 109 and 110: 80 ----- 5. MAINTENANCEDrain off th
Page 111 and 112: 82 ----- 5. MAINTENANCE• Check th
Page 113 and 114: 84 ----- 5. MAINTENANCEDirt and dus
Page 115 and 116: 86 ----- 5. MAINTENANCE(4) Air clea
Page 117 and 118: 88 ----- 5. MAINTENANCE(5) Checking
Page 119 and 120: 90 ----- 5. MAINTENANCE(3) Cleaning
Page 121 and 122: 92 ----- 5. MAINTENANCE(2) Checking
Page 123 and 124: 94 ----- 5. MAINTENANCE5.3.7 Checki
Page 125 and 126: 96 ----- 6. TROUBLESHOOTINGSYMPTOM
Page 127 and 128: 98 ----- 6. TROUBLESHOOTING
Page 129 and 130: 100 ----- 7. ENGINE SPECIFICATIONS
Page 132 and 133: 7. ENGINE SPECIFICATIONS ----- 103
Page 134 and 135: 7. ENGINE SPECIFICATIONS ----- 105
Page 136: All information, illustrations and
show all

INSTRUCTION MANUAL - Alessandri srl

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?