INSTRUCTION MANUAL - Alessandri srl

90 ––––– 5. MAINTENANCE(3) Cleaning oil/water separatorPeriodically wash the oil/water separator element andinside cup with clean fuel oil.1) Prepare a waste oil container.2) Close the fuel cock.3) Turn the retaining ring counter-clockwise and removethe cup. And put the drain in the cup into a waste oilcontainer to dispose properly. Keep retaining springand float ring at hand. (When removing the cup, holdthe bottom of the cup with a piece of rag to prevent thefuel oil from dropping. If you spill fuel, wipe off the spillagecompletely.)4) Remove the element (pull out downward). Wash theelement and inside cup with clean fuel oil.Replace the element with new one if any damaged.5) Insert the element to the bracket. Put the retainingspring and float ring in the cup and install in to thebracket by tightening the retaining ring clockwise.Tightening torque: 13∼16N•m(1.3∼1.6kgf•m)6) Bleed the fuel system. Refer to 3.2.2CloseAir bleeding boltOutletInletFuel cockRetaining ringOpen RetainingspringFloat ringOil / water separatorBracket