INSTRUCTION MANUAL - Alessandri srl

80 ––––– 5. MAINTENANCEDrain off the oil/water separator in the following manner.1) Prepare a waste oil container.2) Close the fuel cock.3) Turn the retaining ring counter-clockwise and removethe cup and put the drain into a waste oil container todispose properly. Keep the retaining spring and floatring at hand. (When removing the cup, hold the bottomof the cup with a piece of rag to prevent the fuel oil fromdropping. If you spill fuel, wipe off the spillage completely.)4) Wash the cup inside with clean fuel oil.5) Put the retaining spring and float ring in the cup andthen install it to the bracket by tightening the retainingring clockwise.Tightening torque: 13∼16N•m (1.3∼1.6kgf•m)6) Be sure to bleed air in the fuel system.Refer to 3.2.2CloseAir bleeding boltOutletInletFuel cockRetaining ringOpen RetainingspringFloat ringOil / water separatorBracket