Rotary Seal Design Guide - Seals Unlimited

Catalog EPS 5350/USAProduct OfferingFlexiLipProfilesTable 9-4. Product ProfilesLFN-NStandardProfileLFN-SBandedProfile*Formed Primary LipFeaturesRecommendedApplicationsMultipurpose SealLFE-NLFE-SFormed Primary Lip w/ Excluder Lip Multipurpose SealLMN-NLMN-SMachined Primary LipLow FrictionLEN-NLEN-SElf-Toe Primary LipAbrasive MediaLEE-NLEE-SElf-Toe Primary Lip w/ Excluder Lip Abrasive MediaLDN-NLDN-SDual Primary LipsOil SealSplash— Flooded, Severe99LDE-NLDE-SDual Primary Lips w/ Excluder Lip Oil Seal — Flooded, SevereSplashLGN-NLGN-SPrimary Lip Energized with Garter SpringSlow, high runoutapplications up to 0.020"(0.51 mm) TIR***Metal Banded — 301 Stainless Steel. For use when temperature is 250 °F (121 °C) or shaft diameter > 4.000" (102 mm).***Consult engineering for shaft diameters that are outside the range of our standards.***Seals that are retained with an extrusion gap smaller than 0.020" (0.5 mm) will go to higher pressures than listed. ConsultEPS Division Engineering.03/28/069-10 Parker Hannifin CorporationEPS DivisionToll Free: (800) 233-3900www.parkerseals.com