EKSpot MALDI Spotter System Operator Guide - Eksigent

Configure the Software and Initialize the System7. In the Configuration tab (Figure 4-6), click Arm Config.The Autosampler Configuration dialog appears (Figure 4-7).Figure 4-7Autosampler Configuration dialog8. In the Comm Port field in the Comm Port Setup area, select the COM portconnected to the EKSpot MALDI spotter.9. Click OK to return to the ekspot Configuration dialog.This re-initializes the spotter (Figure 4-8).Figure 4-8Initializing PAL Spotter dialogEKSpot MALDI Spotter SystemOperator Guide18 of 38 September 2012