EKSpot MALDI Spotter System Operator Guide - Eksigent

More documents

Recommendations

Info

ContentsEKSpot MALDI Spotter SystemOperator Guide4 of 38 September 2012
Chapter 1.Safety and Site RequirementsThis chapter describes safety conventions, safety procedures and site requirements necessaryfor proper operation of the Eksigent EKSpot MALDI spotter system. Topics covered in thischapter include:• EKSpot MALDI Spotter System Safety Practices• Site RequirementsAbout this GuideThis guide is intended for laboratory technicians who are responsible for control and day-to-daymaintenance of the EKSpot MALDI spotter system. It is assumed that the user of this guide isfamiliar with standard laboratory terminology.WARNING! Read the safety instructions and the rest of this guide before usingthe EKSpot MALDI spotter system.Symbols and ConventionsThe following conventions are used throughout the guide.Table 1-1PictorialSymbols and DescriptionsDescriptionThe danger sign warns about a hazard. It calls attention to a procedure orpractice which, if not adhered to, could result in injury or loss of life.Do not proceed beyond a danger sign until the indicated conditions are fullyunderstood and met.The warning sign denotes a hazard. It calls attention to a procedure orpractice which, if not adhered to, could result in severe injury or damage ordestruction of parts or all of the equipment.Do not proceed beyond a warning sign until the indicated conditions are fullyunderstood and met.EKSpot MALDI Spotter SystemOperator Guide5 of 38 September 2012
Page 1 and 2: EKSpot MALDI Spotter SystemOperato
Page 3: ContentsChapter 1. Safety and Site
Page 7 and 8: Safety and Site RequirementsWARNING
Page 9 and 10: Chapter 2.IntroductionOverviewThe E
Page 11 and 12: Chapter 3.InstallationInstall the N
Page 13 and 14: InstallationFigure 3-2Position of t
Page 15 and 16: Chapter 4.Configure the Software an
Page 17 and 18: Configure the Software and Initiali
Page 19 and 20: 10. Click Syringe Config.Configure
Page 21 and 22: Configure the Software and Initiali
Page 23 and 24: Chapter 5.Operate the EKSpot MALDI
Page 26 and 27: Operate the EKSpot MALDI Spotter Sy
Page 32 and 33: Set up the Run Manager Window2. Sel
Page 34 and 35: Set up the Run Manager WindowFigure
Page 36 and 37: Set up the Run Manager WindowEKSpot
Page 38: Index8MT Stack Holder, 27, 34Power

EKSpot MALDI Spotter System Operator Guide - Eksigent

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?