EKSpot MALDI Spotter System Operator Guide - Eksigent

More documents

Recommendations

Info

Set up the Run Manager WindowFigure 6-3Plate assignment in Run Manager window for 4DW stack holderNote: If the 8MT stack holder is installed, Figure 6-4 shows the additionalplate number assignments.Figure 6-4Plate assignment in Run Manager window for 8MT stack holder4. Type the appropriate information in the various columns of the Run Manager windowwith the autosampler, LC, and spotter methods.5. Select the desired Preflush option in the ekspot Configuration dialog.6. In the Run Sequence area of the Run Manager window, select Sequential(Figure 6-5).7. Ensure that Flush/Equilibrate when Idle is cleared (Figure 6-5).This will ensure the drawer remains closed at the end of the run.EKSpot MALDI Spotter SystemOperator Guide34 of 38 September 2012
Set up the Run Manager Window8. Click Start to initiate operation.Figure 6-5Run Sequence area of the Run Manager windowOperator GuideEKSpot MALDI Spotter SystemSeptember 2012 35 of 38
Page 1 and 2: EKSpot MALDI Spotter SystemOperato
Page 3 and 4: ContentsChapter 1. Safety and Site
Page 5 and 6: Chapter 1.Safety and Site Requireme
Page 7 and 8: Safety and Site RequirementsWARNING
Page 9 and 10: Chapter 2.IntroductionOverviewThe E
Page 11 and 12: Chapter 3.InstallationInstall the N
Page 13 and 14: InstallationFigure 3-2Position of t
Page 15 and 16: Chapter 4.Configure the Software an
Page 17 and 18: Configure the Software and Initiali
Page 19 and 20: 10. Click Syringe Config.Configure
Page 21 and 22: Configure the Software and Initiali
Page 23 and 24: Chapter 5.Operate the EKSpot MALDI
Page 26 and 27: Operate the EKSpot MALDI Spotter Sy
Page 32 and 33: Set up the Run Manager Window2. Sel
Page 36 and 37: Set up the Run Manager WindowEKSpot
Page 38: Index8MT Stack Holder, 27, 34Power

EKSpot MALDI Spotter System Operator Guide - Eksigent

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?