EKSpot MALDI Spotter System Operator Guide - Eksigent

More documents

Recommendations

Info

Safety and Site RequirementsEKSpot MALDI Spotter SystemOperator Guide8 of 38 September 2012
Chapter 2.IntroductionOverviewThe Eksigent EKSpot MALDI spotter system is designed to allow the analyst to collect HPLCfractions on a MALDI plate for introduction to a MALDI mass spectrometer.The system consists of the following components:• Eksigent NanoLC system with AS-1 autosampler and Eksigent control software• EKSpot MALDI spotter with matrix addition pumpThis guide describes installation, calibration, and operation of the system.For additional information, refer to the operator guides provided by the manufacturers of thevarious components.EKSpot MALDI Spotter SystemOperator Guide9 of 38 September 2012
Page 1 and 2: EKSpot MALDI Spotter SystemOperato
Page 3 and 4: ContentsChapter 1. Safety and Site
Page 5 and 6: Chapter 1.Safety and Site Requireme
Page 7: Safety and Site RequirementsWARNING
Page 11 and 12: Chapter 3.InstallationInstall the N
Page 13 and 14: InstallationFigure 3-2Position of t
Page 15 and 16: Chapter 4.Configure the Software an
Page 17 and 18: Configure the Software and Initiali
Page 19 and 20: 10. Click Syringe Config.Configure
Page 21 and 22: Configure the Software and Initiali
Page 23 and 24: Chapter 5.Operate the EKSpot MALDI
Page 26 and 27: Operate the EKSpot MALDI Spotter Sy
Page 32 and 33: Set up the Run Manager Window2. Sel
Page 34 and 35: Set up the Run Manager WindowFigure
Page 36 and 37: Set up the Run Manager WindowEKSpot
Page 38: Index8MT Stack Holder, 27, 34Power

EKSpot MALDI Spotter System Operator Guide - Eksigent

Create successful ePaper yourself

Delete template?

Save as template?